Yea,tried that one ,hoping for the best.Worked really good the first
six inches,then.........you know!
Thanks for the reply all.
Jason
817R
On 31-Oct-09, at 2:45 PM, Wayne G. O'Shea wrote:
Yes... it's 6061-T6
(btw.. don't you own the recommended 5lb hand sledge??)
;O)
----- Original Message -----
From: "Garry Wright" <
wright.garry30@gmail.com>
To: <
rebel-builders@dcsol.com>
Sent: Saturday, October 31, 2009 11:00 AM
Subject: Re: [rebel-builders] spreaderbar attach
My machinist friend says and demonstrates that 6061 makes a clunk
when
struck. 7075 makes a nice ring. The nose struts on the floats are
7075
for something to compare with.
Garry
Drew Dalgleish wrote:
I'm pretty sure it's 6061 but not 100%. On most of the tubes in my
kit
there was a manufacturers mark along one side and part of that
mark is
the
grade.
At 08:53 AM 31/10/2009 -0400, you wrote:
Drew
-----------------------------------------------------------------
List archives located at:
https://mail.dcsol.com/login
username "rebel" password "builder"
Unsubscribe:
rebel-builders-unsubscribe@dcsol.com
List administrator:
mike.davis@dcsol.com
-----------------------------------------------------------------
-----------------------------------------------------------------
List archives located at:
https://mail.dcsol.com/login
username "rebel" password "builder"
Unsubscribe:
rebel-builders-unsubscribe@dcsol.com
List administrator:
mike.davis@dcsol.com
-----------------------------------------------------------------
-----------------------------------------------------------------
List archives located at:
https://mail.dcsol.com/login
username "rebel" password "builder"
Unsubscribe:
rebel-builders-unsubscribe@dcsol.com
List administrator:
mike.davis@dcsol.com
-----------------------------------------------------------------
-----------------------------------------------------------------
List archives located at:
https://mail.dcsol.com/login
username "rebel" password "builder"
Unsubscribe:
rebel-builders-unsubscribe@dcsol.com
List administrator:
mike.davis@dcsol.com
-----------------------------------------------------------------