Lower Forward Corner Wraps Moose

[murray]

Hi

MAM tech is closed for a week and I an installing the Lower Forward Corner
Wraps...manual says to overlap the two rows of rivet holes on the lower panel
but the part supplied by MAM looks like it will only cover one hole on the
bottom panel..

Thanks

Murray
SN237



-----------------------------------------------------------------
List archives located at: https://mail.dcsol.com/login
username "rebel" password "builder"
Unsubscribe: rebel-builders-unsubscribe@dcsol.com
List administrator: mike.davis@dcsol.com
-----------------------------------------------------------------

[Al Paxhia]

Murray,
I went through three wraps before I figured out that the two hole overlap
only works at the front. I just shaped the wrap to go from two holes down to
a single hole overlap at the back 2 or 3 rivets.
Al
----- Original Message -----
From: <murray@dcsol.com>
To: <rebel-builders@dcsol.com>
Sent: Friday, January 21, 2005 7:51 PM
Subject: Lower Forward Corner Wraps Moose

Hi

MAM tech is closed for a week and I an installing the Lower Forward Corner
Wraps...manual says to overlap the two rows of rivet holes on the lower
panel
but the part supplied by MAM looks like it will only cover one hole on the
bottom panel..

Thanks

Murray
SN237



-----------------------------------------------------------------
List archives located at: https://www.dcsol.com/login?mode=HTML
username "rebel" password "builder"
Subscription services located at:
https://www.dcsol.com/public/code/html-subscribe.htm
List administrator: mike.davis@dcsol.com
-----------------------------------------------------------------

-----------------------------------------------------------------
List archives located at: https://mail.dcsol.com/login
username "rebel" password "builder"
Unsubscribe: rebel-builders-unsubscribe@dcsol.com
List administrator: mike.davis@dcsol.com
-----------------------------------------------------------------

[murray]

Al,

Thanks for the reply decided to just make up new wraps that covered all the
holes...good to have a shear and roller will up load a picture or two so
others may see.

Thanks Murray



-----------------------------------------------------------------
List archives located at: https://mail.dcsol.com/login
username "rebel" password "builder"
Unsubscribe: rebel-builders-unsubscribe@dcsol.com
List administrator: mike.davis@dcsol.com
-----------------------------------------------------------------

[JACK JOOS]

An added comment:--

I also had to do a second set of bottom corner wraps. It really helps and
does a nice fitting job too if you can use a shrinker to "kink" the edge
that fits under the belly band.

Jack
moose SR193

From: murray@dcsol.com
Reply-To: <rebel-builders@dcsol.com>
Date: Tue, 25 Jan 2005 21:47:49 -0900
To: rebel-builders@dcsol.com
Subject: Re: Lower Forward Corner Wraps Moose

Al,

Thanks for the reply decided to just make up new wraps that covered all the
holes...good to have a shear and roller will up load a picture or two so
others may see.

Thanks Murray



-----------------------------------------------------------------
List archives located at: https://www.dcsol.com/login?mode=HTML
username "rebel" password "builder"
Subscription services located at:
https://www.dcsol.com/public/code/html-subscribe.htm
List administrator: mike.davis@dcsol.com
-----------------------------------------------------------------

-----------------------------------------------------------------
List archives located at: https://mail.dcsol.com/login
username "rebel" password "builder"
Unsubscribe: rebel-builders-unsubscribe@dcsol.com
List administrator: mike.davis@dcsol.com
-----------------------------------------------------------------