SR torque tube

[Jason Beall]

Hi again everyone,

Another question...this time about the tourque tube. I
have read on ahead through the fuselage manual but
there is too much to try to digest to answer this
question quickly...so I will ask the list!

Question: My torque tube has a little bit of
side-to-side play when looking at the wing head on
from the front. What stops this once the rest of the
control system is installed? I have installed the
bushing and washers as per the diagram in the torque
tube installation section of the chapeter on wing
construction.


Thansk,
-Jason

=====
________________________________________________

Jason Beall
Super Rebel No. 131
Aberdeen, Scotland, UK
super_rebel131@yahoo.com

__________________________________________________
Do You Yahoo!?
Yahoo! Health - your guide to health and wellness
http://health.yahoo.com



-----------------------------------------------------------------
List archives located at: https://mail.dcsol.com/login
username "rebel" password "builder"
Unsubscribe: rebel-builders-unsubscribe@dcsol.com
List administrator: mike.davis@dcsol.com
-----------------------------------------------------------------

[Al & Deb Paxhia]

The side to side movement is the difference between the steel bushing
length and the brass bearing in the torque tube. When I installed the
aileron push tubes I moved the torque tube from side to side and determined
that the tube had clearance through the wing spar. At the same time there
were no clearance problems at the wing root push tube, but there is a small
side to side movement.
Al
"Moose" N526AP

----- Original Message -----
From: "Jason Beall" <super_rebel131@yahoo.com>
To: <murphy-rebel@dcsol.com>
Sent: Wednesday, May 01, 2002 1:51 AM
Subject: SR torque tube

Hi again everyone,

Another question...this time about the tourque tube. I
have read on ahead through the fuselage manual but
there is too much to try to digest to answer this
question quickly...so I will ask the list!

Question: My torque tube has a little bit of
side-to-side play when looking at the wing head on
from the front. What stops this once the rest of the
control system is installed? I have installed the
bushing and washers as per the diagram in the torque
tube installation section of the chapeter on wing
construction.


Thansk,
-Jason

=====
________________________________________________

Jason Beall
Super Rebel No. 131
Aberdeen, Scotland, UK
super_rebel131@yahoo.com

__________________________________________________
Do You Yahoo!?
Yahoo! Health - your guide to health and wellness
http://health.yahoo.com

*-------------------------------------------------------------------------*

To unsubscribe go to http://www.dcsol.com:81/public/listserv.htm
Archives located at http://rebel:builder@www.dcsol.com:81/default.htm
To contact the list admin, e-mail mike.davis@dcsol.com

*-------------------------------------------------------------------------*





-----------------------------------------------------------------
List archives located at: https://mail.dcsol.com/login
username "rebel" password "builder"
Unsubscribe: rebel-builders-unsubscribe@dcsol.com
List administrator: mike.davis@dcsol.com
-----------------------------------------------------------------