[rebel-builders] Trim servo wiring

[N.Smith]

Hi Roger

I brought mine out of the centre of the elevator at the leading edge to a
plug about 2 foot from the exit point. The fuselage length runs from a
socket forwards to the controls. The plug/socket fits under the stab in the
rear fuselage cavity.

When I was doing final assembly I attached the cable to a couple of plastic
tie down points to ensure the cable didn't jam in the elevator movement.

Nig
745E

-----Original Message-----
From: mike.davis@dcsol.com [mailto:mike.davis@dcsol.com] On Behalf Of Lynn
Cole
Sent: 04 October 2011 17:18
To: Rebel Builders
Subject: [rebel-builders] Trim servo wiring

I need advice on how to route the trim servo wiring from the elevator
to the fuselage of a Murphy Elite

Lynn Cole
Murphy Elite #709
LynnCole@foxvalley.net







-----------------------------------------------------------------
List archives located at: https://mail.dcsol.com/login
username "rebel" password "builder"
Unsubscribe: rebel-builders-unsubscribe@dcsol.com
List administrator: mike.davis@dcsol.com
-----------------------------------------------------------------






-----------------------------------------------------------------
List archives located at: https://mail.dcsol.com/login
username "rebel" password "builder"
Unsubscribe: rebel-builders-unsubscribe@dcsol.com
List administrator: mike.davis@dcsol.com
-----------------------------------------------------------------