In a nutshell...plan for the door hinge before you rivet, rivet the FUS-11's
when you're ready to rivet all of the front in place. Some have left it
cleco'd well into the build allowing them to remove it and work on the rear
of their panel, others, like me, couldn't wait and now lie on our backs to
work there <grin>. Probably makes the most sense to leave it cleco'd as
long as you can; you really don't need it riveted until you hang your eng.
CW
----- Original Message -----
From: "Roland Kriening" <kriening@rogers.com>
To: <rebel-builders@dcsol.com>
Sent: Wednesday, September 22, 2010 11:35 AM
Subject: [rebel-builders] fus 11 side panels - when to rivet
Just finished making and preparing all parts for the forward section -
firewall, etc. I have looked through the plans and cannot find mention of
when to rivet fus 11 (side panels) to the cage uprights. The instructions
only mention drilling a top and bottom hole, which was done some time ago.
I
would assume that the door hinge attaches here as well, but cant find any
mention of fus 11 in the door installation section.
Looking for help from those ahead of me in the build.
Roland
R56
-----------------------------------------------------------------
List archives located at: https://mail.dcsol.com/login
username "rebel" password "builder"
Unsubscribe: rebel-builders-unsubscribe@dcsol.com
List administrator: mike.davis@dcsol.com
-----------------------------------------------------------------
-----------------------------------------------------------------
List archives located at: https://mail.dcsol.com/login
username "rebel" password "builder"
Unsubscribe: rebel-builders-unsubscribe@dcsol.com
List administrator: mike.davis@dcsol.com
-----------------------------------------------------------------