[rebel-builders] Rebel / Elite - Dipstick clearance on Dynaf

[Alan Hepburn]

My mount was wrong and Murphy replaced it - but that's about 5 years ago.

Al Hepburn

-----Original Message-----
From: mike.davis@dcsol.com [mailto:mike.davis@dcsol.com] On Behalf Of Wayne
G. O'Shea
Sent: Tuesday, March 23, 2010 11:45 PM
To: Murphy Rebel Builders List
Subject: [rebel-builders] Rebel / Elite - Dipstick clearance on Dynafocal
mounts

Someone asked if it was a common issue that his dipstick tube was hitting
the mount a while back....

.. .. so while bolting up the latest (O-320-E2D) engine installation today,
I took a picture after everything was tightened up.

This has been the typical clearance on every Dynafocal engine I've mounted
to a Murphy made mount. About 3/16 to 1/4"....so not sure why the fella
had/has issues.

http://www.irishfield.on.ca/gallery/dip ... omount.jpg





-----------------------------------------------------------------
List archives located at: https://mail.dcsol.com/login
username "rebel" password "builder"
Unsubscribe: rebel-builders-unsubscribe@dcsol.com
List administrator: mike.davis@dcsol.com
-----------------------------------------------------------------







-----------------------------------------------------------------
List archives located at: https://mail.dcsol.com/login
username "rebel" password "builder"
Unsubscribe: rebel-builders-unsubscribe@dcsol.com
List administrator: mike.davis@dcsol.com
-----------------------------------------------------------------