Spinners

[Wayne G. O'Shea]

Well I did.....until you gave out their phone # direct ...since they don't
advertise for retail sales and they let us "dealers" take care of things for
them! Thanks, I'm trying to downsize anyhow I guess! Wayne


----- Original Message -----
From: "british thunder" <britishthunder@sympatico.ca>
To: <rebel-builders@dcsol.com>
Sent: Thursday, March 10, 2005 7:54 AM
Subject: Re: spinners

Clay
Not sure where you are, but I have had good luck getting spinners from

UHS.

They are fibreglass and usually ships the next day balanced and all

hardware

included.
905534
I think Wayne sells them as well.

----- Original Message -----
From: "Ralph Baker" <rebaker@ftc-i.net>
To: <rebel-builders@dcsol.com>
Sent: Wednesday, March 09, 2005 8:53 AM
Subject: spinners

Clay,
If you are using the "speed cowl" it seems to me that any spinner that
leaves a gap between the spinner edge to the cowl intake will require
the air passing down the side of the spinner to "bounce" off the flat
face of the cowl creating turbulence at the intakes and restricting the
flow of incoming air. On our speed cowl that requires a full 13"
diameter.

We elected to go with the Van's fiberglass spinner for ease of
installation. You can see exactly where to drill and the bulkheads are
fitted to the Sensenich prop thickness.
Ralph Baker



-----------------------------------------------------------------
List archives located at: https://www.dcsol.com/login?mode=HTML
username "rebel" password "builder"
Subscription services located at:
https://www.dcsol.com/public/code/html-subscribe.htm
List administrator: mike.davis@dcsol.com
-----------------------------------------------------------------

-----------------------------------------------------------------
List archives located at: https://www.dcsol.com/login?mode=HTML
username "rebel" password "builder"
Subscription services located at:
https://www.dcsol.com/public/code/html-subscribe.htm
List administrator: mike.davis@dcsol.com
-----------------------------------------------------------------

-----------------------------------------------------------------
List archives located at: https://mail.dcsol.com/login
username "rebel" password "builder"
Unsubscribe: rebel-builders-unsubscribe@dcsol.com
List administrator: mike.davis@dcsol.com
-----------------------------------------------------------------

[Rebecca Brownell]

Hi all
Trying to figure out my spinner options here.Are those UCS spinners
from spruce any good?Does one usually order them pre cut ?

Thanks,Jason
817R



-----------------------------------------------------------------
List archives located at: https://mail.dcsol.com/login
username "rebel" password "builder"
Unsubscribe: rebel-builders-unsubscribe@dcsol.com
List administrator: mike.davis@dcsol.com
-----------------------------------------------------------------