Parts do not fit

[Roger Cole]

Instruction 9.23.9 says "Align the FUS-86 part inside the FUS-85
bracket, then mark and trim off the end of FUS-85 as shown." The
problem is that the FUS-86 is 1-inch thick, and the inside width of
FUS-85 is 15/16 inch. FUS-86 does not fit inside FUS-85. Should I
machine 1/32 inch off each side of the FUS-86?

Roger Cole
Murphy Elite #709
rcole927@earthlink.net







-----------------------------------------------------------------
List archives located at: https://mail.dcsol.com/login
username "rebel" password "builder"
Unsubscribe: rebel-builders-unsubscribe@dcsol.com
List administrator: mike.davis@dcsol.com
-----------------------------------------------------------------

[Roger Cole]

Instruction 9.23.9 says "Align the FUS-86 part inside the FUS-85
bracket, then mark and trim off the end of FUS-85 as shown." The
problem is that the FUS-86 is 1-inch thick, and the inside width of
FUS-85 is 15/16 inch. FUS-86 does not fit inside FUS-85. Should I
machine 1/32 inch off each side of the FUS-86?

Roger Cole
Murphy Elite #709
rcole927@earthlink.net







-----------------------------------------------------------------
List archives located at: https://mail.dcsol.com/login
username "rebel" password "builder"
Unsubscribe: rebel-builders-unsubscribe@dcsol.com
List administrator: mike.davis@dcsol.com
-----------------------------------------------------------------