I figured out that I should be able to use the stringers on the left
wing(inside+correct orientation) though, right?. My Inspector threatned me
with a wing load test if I don't stick to the manual!
Another question: the torque tube moves still quite "stiff" - how free does
free moving as stated in the manual mean? Is there a trick how to sand
delrin easily?
thanks,
Dieter
778R
----- Original Message -----
From: "Drew Dalgleish" <drewjan@cabletv.on.ca>
To: <rebel-builders@dcsol.com>
Sent: Wednesday, January 09, 2008 2:54 PM
Subject: Re: [rebel-builders] stringer orientation
Opps My bad For some reason I was thinking that the rivet spacing was only
different on the leading edge skin.
At 10:39 PM 1/7/2008 -0800, you wrote:DrewDon't think you can swap sides as the rivet spacing is different on the
inboard and outboard ends of the skin.
Ken
Drew Dalgleish wrote:Hi Dieter I don't think it matters either but if you used that skin for
your second wing they'd be facing the right way.
At 11:27 PM 1/7/2008 +0100, you wrote:
-----------------------------------------------------------------
List archives located at: https://mail.dcsol.com/login
username "rebel" password "builder"
Unsubscribe: rebel-builders-unsubscribe@dcsol.com
List administrator: mike.davis@dcsol.com
-----------------------------------------------------------------
-----------------------------------------------------------------
List archives located at: https://mail.dcsol.com/login
username "rebel" password "builder"
Unsubscribe: rebel-builders-unsubscribe@dcsol.com
List administrator: mike.davis@dcsol.com
-----------------------------------------------------------------
