This is another place to use the large nylon 'pog' washers -
out next to the supports. They can be snug, without wear....
just like on the ends of the elevators & rudder. You don't
want any end play, or everything wears quickly.
--
......bobp
http://www.prosumers.ca
http://bpatterson.qhealthbeauty.com
http://apatterson2.qhealthzone.com
http://apatterson2.ordermygift.com
-------------------------------orig.-------------------------
On Tuesday 11 December 2007 01:20, Ronald Shannon wrote:
Working on "final" install of the flaperons. The space between flaperons
and their hinges varies from 1-3 std. washer widths, depending on how the
three bolts per wing are snugged up. It seems there are three places to
describe/spec this: 1) each side of the center hinge (two places but
presumably they should be more or less the same), 2) each end hinge, and 3)
the resulting space between the flaperon horns where the push tube bearing
end connects.
Obviously, chafe or binding with the hinges needs to be eliminated. Beyond
that, what's the optimal setup, if there's "extra" room for adjustment?
Should washers be used to fill any small gaps?
Ron
-----------------------------------------------------------------
List archives located at: https://mail.dcsol.com/login
username "rebel" password "builder"
Unsubscribe: rebel-builders-unsubscribe@dcsol.com
List administrator: mike.davis@dcsol.com
-----------------------------------------------------------------