then use my air shear to cut the fingers out.
----- Original Message -----
From: "David L. Tuck" <dltuck53@hotmail.com>
To: <rebel-builders@dcsol.com>
Sent: Monday, November 12, 2007 6:12 PM
Subject: [rebel-builders] SG 14
Well I'm at the point of installing the famed spring gear.
The manual says to lighten the SG 14, this is where you cut a 2 1/8
hole between the ribs and then cut them out on an angle
O
/ \
this shows a little what it looks like?
My question then is can I leave the SG14 as a whole plate rather than cut
them this way? On the inside of the cabin where the seat rails will go, I
just don't like the way it will look!
Any help out there?
Thanks
Dave T.
Rebel 009
_________________________________________________________________
Climb to the top of the charts! Play Star Shuffle: the word scramble
challenge with star power.
http://club.live.com/star_shuffle.aspx? ... xtlink_oct
-----------------------------------------------------------------
List archives located at: https://mail.dcsol.com/login
username "rebel" password "builder"
Unsubscribe: rebel-builders-unsubscribe@dcsol.com
List administrator: mike.davis@dcsol.com
-----------------------------------------------------------------
-----------------------------------------------------------------
List archives located at: https://mail.dcsol.com/login
username "rebel" password "builder"
Unsubscribe: rebel-builders-unsubscribe@dcsol.com
List administrator: mike.davis@dcsol.com
-----------------------------------------------------------------
