[rebel-builders] tach cable

[steve whitenect]

straight as possible

Steve w

From: "Jones, Michael" <Michael.Jones@snclavalin.com>
Reply-To: <rebel-builders@dcsol.com>
To: rebel-builders@dcsol.com
Subject: [rebel-builders] tach cable
Date: Mon, 30 Oct 2006 12:24:23 -0500

Hi all



Am ordering tach cable and am wondering if I should allow for some extra in
cable to allow for engine moving or just run it straight with as few bends
as possible



Mike#007





-----------------------------------------------------------------
List archives located at: https://mail.dcsol.com/login
username "rebel" password "builder"
Unsubscribe: rebel-builders-unsubscribe@dcsol.com
List administrator: mike.davis@dcsol.com
-----------------------------------------------------------------

_________________________________________________________________
Ready for the world's first international mobile film festival celebrating
the creative potential of today's youth? Check out Mobile Jam Fest for your
a chance to WIN $10,000! www.mobilejamfest.com




-----------------------------------------------------------------
List archives located at: https://mail.dcsol.com/login
username "rebel" password "builder"
Unsubscribe: rebel-builders-unsubscribe@dcsol.com
List administrator: mike.davis@dcsol.com
-----------------------------------------------------------------

[Wayne G. O'Shea]

If you can't do that...and I had bad luck with that although it turned out
it wasn't the cable it was a bad new mitchell tach...use a long cable that
can make a BIG diameter loop with it behind the tach. I believe my cable is
either a 39 or 41" Cessna Tach cable. I have it come thru the firewall in
line with the engine drive and then it comes in turns a large 90 and does a
full 270 (using the width between firewall and panel) into the tach. No
issues in 11 years.

Wayne

----- Original Message -----
From: "steve whitenect" <srwhitenect@hotmail.com>
To: <rebel-builders@dcsol.com>
Sent: Monday, October 30, 2006 2:09 PM
Subject: RE: [rebel-builders] tach cable

straight as possible

Steve w

From: "Jones, Michael" <Michael.Jones@snclavalin.com>
Reply-To: <rebel-builders@dcsol.com>
To: rebel-builders@dcsol.com
Subject: [rebel-builders] tach cable
Date: Mon, 30 Oct 2006 12:24:23 -0500

Hi all



Am ordering tach cable and am wondering if I should allow for some extra
in
cable to allow for engine moving or just run it straight with as few bends
as possible



Mike#007





-----------------------------------------------------------------
List archives located at: https://mail.dcsol.com/login
username "rebel" password "builder"
Unsubscribe: rebel-builders-unsubscribe@dcsol.com
List administrator: mike.davis@dcsol.com
-----------------------------------------------------------------

_________________________________________________________________
Ready for the world's first international mobile film festival celebrating
the creative potential of today's youth? Check out Mobile Jam Fest for
your
a chance to WIN $10,000! www.mobilejamfest.com




-----------------------------------------------------------------
List archives located at: https://mail.dcsol.com/login
username "rebel" password "builder"
Unsubscribe: rebel-builders-unsubscribe@dcsol.com
List administrator: mike.davis@dcsol.com
-----------------------------------------------------------------

-----------------------------------------------------------------
List archives located at: https://mail.dcsol.com/login
username "rebel" password "builder"
Unsubscribe: rebel-builders-unsubscribe@dcsol.com
List administrator: mike.davis@dcsol.com
-----------------------------------------------------------------