[rebel-builders] Finishing the aileron torque tube

[Dale Fultz]

Hi Mike,,,, GO to Chapter 12 Controls,, Step 80 page 29 is where you will
find the information in the MANUAL.. Dale SR-033
-----




-----------------------------------------------------------------
List archives located at: https://mail.dcsol.com/login
username "rebel" password "builder"
Unsubscribe: rebel-builders-unsubscribe@dcsol.com
List administrator: mike.davis@dcsol.com
-----------------------------------------------------------------

[Mike Kimball]

There it is! Thanks Dale.

Mike

-----Original Message-----
From: mike.davis@dcsol.com [mailto:mike.davis@dcsol.com] On Behalf Of Dale
Fultz
Sent: Monday, May 22, 2006 4:52 AM
To: rebel-builders@dcsol.com
Subject: Re: [rebel-builders] Finishing the aileron torque tube

Hi Mike,,,, GO to Chapter 12 Controls,, Step 80 page 29 is where you will
find the information in the MANUAL.. Dale SR-033
-----




-----------------------------------------------------------------
List archives located at: https://www.dcsol.com/login
username "rebel" password "builder"
Unsubscribe: rebel-builders-unsubscribe@dcsol.com
List administrator: mike.davis@dcsol.com
-----------------------------------------------------------------






-----------------------------------------------------------------
List archives located at: https://mail.dcsol.com/login
username "rebel" password "builder"
Unsubscribe: rebel-builders-unsubscribe@dcsol.com
List administrator: mike.davis@dcsol.com
-----------------------------------------------------------------

[Reed Britt Civ 309 MXSG/M]

Mike - Did you catch the reference to putting safety wire on the outboard
end of the Aileron Torque tube bolt(pivot point)? - I had one wing finished
that I have to go back and do but I had the other one still opened up when
Scott Aldrich gave me the heads up and it was easy to do.

Britt A. Reed
309th MXSS/MDEA
5832 H Ave. Bldg 843
Hill AFB UT 84056

(801) 775 4471


-----Original Message-----
From: mike.davis@dcsol.com [mailto:mike.davis@dcsol.com] On Behalf Of Mike
Kimball
Sent: Sunday, May 21, 2006 9:30 PM
To: Rebel Builder's List
Subject: [rebel-builders] Finishing the aileron torque tube

I've got the fuselage on its gear and the wings ready to mount and I notice
that I still haven't finished off the aileron torque tubes at the wing root
end. I scoured the manual and, no surprise, I cannot find anything that
tells me what I'm supposed to attach to that end. I found some El-31
fittings to go inside the 2-inch tube, and the little rings to go outside
the tube for the rivets, and some straight horns that are 4 inches from
pivot point to attach point. I'm guessing these are the parts to use. But
I guess I'll be on my own for figuring out what direction the horn should be
pointing when I rivet it on. Any tips? Are these the right parts?

Mike
044SR




-----------------------------------------------------------------
List archives located at: https://www.dcsol.com/login
username "rebel" password "builder"
Unsubscribe: rebel-builders-unsubscribe@dcsol.com
List administrator: mike.davis@dcsol.com
-----------------------------------------------------------------





-----------------------------------------------------------------
List archives located at: https://mail.dcsol.com/login
username "rebel" password "builder"
Unsubscribe: rebel-builders-unsubscribe@dcsol.com
List administrator: mike.davis@dcsol.com
-----------------------------------------------------------------