something?
The caliper mounting plate (Matco) that slides over the axle to be
attached to the flange - on the axle - only goes as far as the ridge or
increase in diameter of the axle from 3/4 to 7/8. Am I missing
something? I feel the hole in the caliper mounting plate should be 7/8
and slide right to the flange and that the ridge is for the bearing to
butt up against?? I don't have a 7/8 inch drill - any suggestions?
Thanks
Jim
Rebel 333
-----------------------------------------------------------------
List archives located at: https://www.dcsol.com/login
username "rebel" password "builder"
Unsubscribe: rebel-builders-unsubscribe@dcsol.com
List administrator: mike.davis@dcsol.com
-----------------------------------------------------------------
-----------------------------------------------------------------
List archives located at: https://mail.dcsol.com/login
username "rebel" password "builder"
Unsubscribe: rebel-builders-unsubscribe@dcsol.com
List administrator: mike.davis@dcsol.com
-----------------------------------------------------------------
