Rebel: Bottom fin hinge bracket

[Wayne G. O'Shea]

No I'm talking about this..but without drilling the relief holes MAM shows
in the corner to bend the flange up at. These just give another place for
the cracks to start.

http://www.murphyair.com/SUPPORT/Bullet ... 520REB.PDF

----- Original Message -----
From: "Ian Donaldson" <allsure@bigpond.net.au>
To: <rebel-builders@dcsol.com>
Sent: Sunday, November 06, 2005 5:52 PM
Subject: Re: Rebel: Bottom fin hinge bracket

G'day Wayne

the ..032 doubler on the rear end of the Fus-31 to the fin tail post
attachment.

OK! If you are referring to the "tail wrap" that you invented, I have that
done.

Thanks again

regards
Ian Donaldson




-----------------------------------------------------------------
List archives located at: https://www.dcsol.com/login
username "rebel" password "builder"
Subscription services located at:
https://www.dcsol.com/public/code/html-subscribe.htm
List administrator: mike.davis@dcsol.com
-----------------------------------------------------------------

-----------------------------------------------------------------
List archives located at: https://mail.dcsol.com/login
username "rebel" password "builder"
Unsubscribe: rebel-builders-unsubscribe@dcsol.com
List administrator: mike.davis@dcsol.com
-----------------------------------------------------------------

[Ian Donaldson]

G'day Wayne

Thanks for that. I was not aware that a modification had to be done!

At least I found about it at the right time as I can do it when I am sorting
out the bolts in the bracket.


Thanks again and regards


Ian Donaldson

No I'm talking about this..but without drilling the relief holes MAM shows
in the corner to bend the flange up at. These just give another place for
the cracks to start.

http://www.murphyair.com/SUPPORT/Bullet ... 520REB.PDF

-----------------------------------------------------------------
List archives located at: https://mail.dcsol.com/login
username "rebel" password "builder"
Unsubscribe: rebel-builders-unsubscribe@dcsol.com
List administrator: mike.davis@dcsol.com
-----------------------------------------------------------------