Tank skin overlap

[Jesse Jenks]

Great,
Thanks again!
Jesse

From: Ken <klehman@albedo.net>
Reply-To: <rebel-builders@dcsol.com>
To: rebel-builders@dcsol.com
Subject: Re: Tank skin overlap
Date: Tue, 19 Jul 2005 22:00:09 -0400

Jesse this is the place to ask if you can't figure it out from the
manual! I recall my manual saying to go back and drill another hole
between the existing ones on the main spar for the tank skin on my
standard Rebel. I just measured and my spacing is about 5/8" on the
bottom of the tank and about 1/2 on the top.
Ken

Jesse Jenks wrote:

Ken,
Very helpfull. Thanks a bunch.
One more question, the last one, I promise: Along the main spar in the

tank

area should I add aditional rivets between the existing ones? The manual
doesn't seem to show a picture of that area, but does show twice the
existing number of holes put along both the inboard and outboard tank

ribs,

and the spacing on the tank bulkheads is pretty close also.
Jesse

-----------------------------------------------------------------
List archives located at: https://www.dcsol.com/login
username "rebel" password "builder"
Subscription services located at:
https://www.dcsol.com/public/code/html-subscribe.htm
List administrator: mike.davis@dcsol.com
-----------------------------------------------------------------

-----------------------------------------------------------------
List archives located at: https://mail.dcsol.com/login
username "rebel" password "builder"
Unsubscribe: rebel-builders-unsubscribe@dcsol.com
List administrator: mike.davis@dcsol.com
-----------------------------------------------------------------