comes to 'reamers' etc. As usual there have been a lot of good tips -
thanks again
Jim
SR083Moose
Nielsenbe@aol.com wrote:
my $.02 on reamers in general is don't stop them in the hole, run them until
they are completely removed. Watch the RPM range some of the higher speed
air drills can turn the reamer into a router bit. I have used a reamer on a lot
of the tail parts and it saves on the deburring...... seems so anyway.
Brad
-----------------------------------------------------------------
List archives located at: https://www.dcsol.com/login?mode=HTML
username "rebel" password "builder"
Subscription services located at:
https://www.dcsol.com/public/code/html-subscribe.htm
List administrator: mike.davis@dcsol.com
-----------------------------------------------------------------
-----------------------------------------------------------------
List archives located at: https://mail.dcsol.com/login
username "rebel" password "builder"
Unsubscribe: rebel-builders-unsubscribe@dcsol.com
List administrator: mike.davis@dcsol.com
-----------------------------------------------------------------
