moose rudder trim??

[Warren & Marg Montgomery]

East or West? Correalis or left foot forward??
With the M14s reverse rotation I hinged my trim so it would close the
gap when used.
Left foot, left rudder, right trim. So I recall it's hinged on the left
side?
Hope I calculated it correct??
Warren

Reed Britt Civ OO-ALC/MADE wrote:

Brad - Are you planning on flying in the Northern Hemisphere or the Southern
Hemisphere?

Actually a good question - I didn't even think about it - I too am going to
run a v8 - I think the different PSRU's might spin different directions but
I haven't worried about it yet - I did think about a gap seal on the super
large elevator trim -

Britt SR194


-----Original Message-----
From: mike.davis@dcsol.com [mailto:mike.davis@dcsol.com] On Behalf Of
Nielsenbe@aol.com
Sent: Monday, December 13, 2004 1:26 PM
To: rebel-builders@dcsol.com
Subject: Re: moose rudder trim??

The other question is what side the trim tab should hinge on. I am planning

on a V-8 installation as of now. With so many other people ahead of my you
guys will have most of the bugs worked out.........thanks

Brad




-----------------------------------------------------------------
List archives located at: https://www.dcsol.com/login?mode=HTML
username "rebel" password "builder"
Subscription services located at:
https://www.dcsol.com/public/code/html-subscribe.htm
List administrator: mike.davis@dcsol.com
-----------------------------------------------------------------





-----------------------------------------------------------------
List archives located at: https://www.dcsol.com/login?mode=HTML
username "rebel" password "builder"
Subscription services located at:
https://www.dcsol.com/public/code/html-subscribe.htm
List administrator: mike.davis@dcsol.com
-----------------------------------------------------------------

-----------------------------------------------------------------
List archives located at: https://mail.dcsol.com/login
username "rebel" password "builder"
Unsubscribe: rebel-builders-unsubscribe@dcsol.com
List administrator: mike.davis@dcsol.com
-----------------------------------------------------------------

[larry173]

Yes they do. I am told that it has heavier gears that the air boat stinger
and the Predator. They also supposed to be modifying it so you can use a
hydraulic prop. Don't know if it is done yet.
----- Original Message -----
From: "Reed Britt Civ OO-ALC/MADE" <Britt.REED@HILL.af.mil>
To: <rebel-builders@dcsol.com>
Sent: Tuesday, December 14, 2004 8:46 AM
Subject: RE: moose rudder trim??

That is interesting - I didn't know that team 38 also uses the Stinger.

-----Original Message-----
From: mike.davis@dcsol.com [mailto:mike.davis@dcsol.com] On Behalf Of
larry173
Sent: Monday, December 13, 2004 2:27 PM
To: rebel-builders@dcsol.com
Subject: Re: moose rudder trim??

All the chain and belts drive are CW , all 3 gear drives are CW, 2 gear
drives (Predators and Team 38 uses a Stinger drive) and they are CCW
----- Original Message -----
From: "Reed Britt Civ OO-ALC/MADE" <Britt.REED@HILL.af.mil>
To: <rebel-builders@dcsol.com>
Sent: Monday, December 13, 2004 4:00 PM
Subject: RE: moose rudder trim??

Brad - Are you planning on flying in the Northern Hemisphere or the
Southern
Hemisphere?

Actually a good question - I didn't even think about it - I too am going
to
run a v8 - I think the different PSRU's might spin different directions
but
I haven't worried about it yet - I did think about a gap seal on the
super
large elevator trim -

Britt SR194


-----Original Message-----
From: mike.davis@dcsol.com [mailto:mike.davis@dcsol.com] On Behalf Of
Nielsenbe@aol.com
Sent: Monday, December 13, 2004 1:26 PM
To: rebel-builders@dcsol.com
Subject: Re: moose rudder trim??

The other question is what side the trim tab should hinge on. I am
planning

on a V-8 installation as of now. With so many other people ahead of my
you
guys will have most of the bugs worked out.........thanks

Brad




-----------------------------------------------------------------
List archives located at: https://www.dcsol.com/login?mode=HTML
username "rebel" password "builder"
Subscription services located at:
https://www.dcsol.com/public/code/html-subscribe.htm
List administrator: mike.davis@dcsol.com
-----------------------------------------------------------------





-----------------------------------------------------------------
List archives located at: https://www.dcsol.com/login?mode=HTML
username "rebel" password "builder"
Subscription services located at:
https://www.dcsol.com/public/code/html-subscribe.htm
List administrator: mike.davis@dcsol.com
-----------------------------------------------------------------

-----------------------------------------------------------------
List archives located at: https://www.dcsol.com/login?mode=HTML
username "rebel" password "builder"
Subscription services located at:
https://www.dcsol.com/public/code/html-subscribe.htm
List administrator: mike.davis@dcsol.com
-----------------------------------------------------------------





-----------------------------------------------------------------
List archives located at: https://www.dcsol.com/login?mode=HTML
username "rebel" password "builder"
Subscription services located at:
https://www.dcsol.com/public/code/html-subscribe.htm
List administrator: mike.davis@dcsol.com
-----------------------------------------------------------------

-----------------------------------------------------------------
List archives located at: https://mail.dcsol.com/login
username "rebel" password "builder"
Unsubscribe: rebel-builders-unsubscribe@dcsol.com
List administrator: mike.davis@dcsol.com
-----------------------------------------------------------------