stabilizer fairings Rivnuts

[LisaFly99]

In a message dated 2/21/04 11:24:05 PM Central Standard Time,
rebaker@ftc-i.net writes:

I am in the Rivnut camp. I prefer to use the keyed ones and put a
little epoxy under them when installing. Haven't had one spin yet and
if you get a spin or strip they can be drilled and reinstalled.
Sheetmetal screws are an abomination !

I used a lot of rivnuts or nutserts and I'm with Ralph in that I always use a
little JB Weld on them when I install them. Or if there where you can get at
the back of them scuff with a Dremil and brush attachment and apply a little
JB Weld. Really locks them in good.
Phil&Lisa Smith
#460R
N414D



*-------------------------------------------------------------------------*
To unsubscribe from this list go to:
https://www.dcsol.com/public/code/html-subscribe.wcx
Archives located at https://www.dcsol.com/default.htm
Archives public username "rebel" password "builder"
To contact the list admin, e-mail mike.davis@dcsol.com
*-------------------------------------------------------------------------*








-----------------------------------------------------------------
List archives located at: https://mail.dcsol.com/login
username "rebel" password "builder"
Unsubscribe: rebel-builders-unsubscribe@dcsol.com
List administrator: mike.davis@dcsol.com
-----------------------------------------------------------------