I set the shelf below the fin to be level with the cabin floor when I built
the fuselage. Then set the bottom of the fin to be level with the shelf.
Will check mine tomorrow and let you know how it accually came out.
Al
----- Original Message -----
From: "Don Boardman" <dboardm3@twcny.rr.com>
To: <murphy-rebel@dcsol.com>
Sent: Saturday, February 16, 2002 4:58 PM
Subject: SR: Installing the Fin
"haveHi all,
I quite today's workshop session with the vertical fin installed with one
cleco and some clamps. Tomorrow I will be setting it vertical, using a
level, and finishing it's installation.
Do I want to set the cabin door posts vertical?
Do I want to have the cabin floor horizontal?
Do I want the shelf under the Vertical Fin where the Horizontal Stab is
installed horizontal?
If there is not total agreement with the above area's which is best to
**plumb"?
Any advice as to how to "true" the fuselage so that a level may be used to
set the Fin vertical would be appreciated.
Thanks,
Don Boardman
& Partner
Randy Bowers
SR130 Rome, NY
** To unsubscribe, send e-mail to list-server@dcsol.com with
**** UNSUBSCRIBE MURPHY-REBEL in the message body on a line by itself
**** Archives located at http://rebel:builder@www.dcsol.com:81/default.htm
**** To contact the list admin, e-mail mike.davis@dcsol.com
-----------------------------------------------------------------
List archives located at: https://mail.dcsol.com/login
username "rebel" password "builder"
Unsubscribe: rebel-builders-unsubscribe@dcsol.com
List administrator: mike.davis@dcsol.com
-----------------------------------------------------------------
