and only use them for interior channels and such. Order a new box from
Mattic Industries.
MAM exchanged them at one point in time....
----- Original Message -----
From: "kevin curtis" <kcs1911@yahoo.com>
To: <rebel-builders@dcsol.com>
Sent: Sunday, May 09, 2010 10:40 PM
Subject: [rebel-builders] rivet mandrels
I have been doing a little work on my kit. I have found that about half of
the rivets leave a little sharp edge of the mandrel sticking out. Is this
common, or if not what can I do to stop it? Should I try turning the air
down so it pulls slower? or up to really pull them fast?
Kevin
623R
-----------------------------------------------------------------
List archives located at: https://mail.dcsol.com/login
username "rebel" password "builder"
Unsubscribe: rebel-builders-unsubscribe@dcsol.com
List administrator: mike.davis@dcsol.com
-----------------------------------------------------------------
-----------------------------------------------------------------
List archives located at: https://mail.dcsol.com/login
username "rebel" password "builder"
Unsubscribe: rebel-builders-unsubscribe@dcsol.com
List administrator: mike.davis@dcsol.com
-----------------------------------------------------------------