Hello
Along with other mods to the tail end, I've replaced my stinger with a piece
of spring steel of 1.040" .. This required opening out the 1" pivot to suit.
Unfortunately, my lathe was being repaired so I gave it to a local workshop.
They have mis-judged and bored it to 1.043" .. 3 thou is not much but
it does make it a bit of a loose fit. Has anyone experienced one of these
with a loose fit? Or can anyone offer any suggestions as to the effect
on the airframe? I believe it should only be an issue bouncing along the
ground but not sure how much of an issue.
I look forward to hearing anyone thoughts on this.
Roger K
SR210
-----------------------------------------------------------------
List archives located at: https://mail.dcsol.com/login
username "rebel" password "builder"
Unsubscribe: rebel-builders-unsubscribe@dcsol.com
List administrator: mike.davis@dcsol.com
-----------------------------------------------------------------
Do you want this big green box to go away? Well here's how...
Click here for full update
Wildcat! photo archives restored.
Click here for full update
Donors can now disable ads.
Click here for instructions
Add yourself to the user map.
Click here for instructions
Click here for full update
Wildcat! photo archives restored.
Click here for full update
Donors can now disable ads.
Click here for instructions
Add yourself to the user map.
Click here for instructions