[rebel-builders] Washers on torque tubes

[Roland Kriening]

Thanks Mike.. I will do the same...

Roland
R56

-----Original Message-----
From: mike.davis@dcsol.com [mailto:mike.davis@dcsol.com] On Behalf Of
mikeh@dcsol.com
Sent: Friday, November 27, 2009 5:45 AM
To: rebel-builders@dcsol.com
Subject: [rebel-builders] Washers on torque tubes

I set out to follow my manuals instructions and fit a washer at each end.
However during the rivetting process (I think) clearances altered a little
and I found the torque tube fitted best with only a washer at one end. I'm
comfortable with this although it may allow faster wear in places. I still
expect 818R to be flying long after I'm not. Cheers
Mike



-----------------------------------------------------------------
List archives located at: https://mail.dcsol.com/login
username "rebel" password "builder"
Unsubscribe: rebel-builders-unsubscribe@dcsol.com
List administrator: mike.davis@dcsol.com
-----------------------------------------------------------------






-----------------------------------------------------------------
List archives located at: https://mail.dcsol.com/login
username "rebel" password "builder"
Unsubscribe: rebel-builders-unsubscribe@dcsol.com
List administrator: mike.davis@dcsol.com
-----------------------------------------------------------------