Rebel- Wing leading edge skin

[Keith Leitch]

I am currently installing the stringers on the leading
edge skin. On the side that faces the bottom of the
wing...nearest stringer to the tip....there seems to
be a space between the predrilled holes where one hole
appears missing. This is about 5 inches over and 5
inches in from the large inspection hole. It is
missing on both skins. Is there suppose to be a hole
there and it was not punched at the factory? Or is
this space left unrivetted for a reason?

Keith R661



____________________________________________________________________________________
Finding fabulous fares is fun.
Let Yahoo! FareChase search your favorite travel sites to find flight and hotel bargains.
http://farechase.yahoo.com/promo-generic-14795097



-----------------------------------------------------------------
List archives located at: https://mail.dcsol.com/login
username "rebel" password "builder"
Unsubscribe: rebel-builders-unsubscribe@dcsol.com
List administrator: mike.davis@dcsol.com
-----------------------------------------------------------------

[bransom]

Keith,
Not sure my reply is of much use because my kit is a little older, 496R,
before they showed the mid-wing inspection hole. As well, I'm not positive
what you mean by "nearest stringer to the tip". However, on my wing skins
there were no gaps in pre-punched holes anywhere. That includes LE skins
and main skins. The only differences are change in pitch (rivet spacing)
and as you know, that is how you determine left/right, inside/outside,
root/tip. I wonder if you might look at how and where the inspection hole
doubler will tie in to the stringers. Even here though, I used the regular
spacing of the prepunched skin holes.
-Ben

On 2/16/2007 1:31 PM, im_planecrazy@yahoo.com wrote to rebel-builders:

I am currently installing the stringers on the leading
edge skin. On the side that faces the bottom of the
wing...nearest stringer to the tip....there seems to
be a space between the predrilled holes where one hole
appears missing. This is about 5 inches over and 5
inches in from the large inspection hole. It is
missing on both skins. Is there suppose to be a hole
there and it was not punched at the factory? Or is
this space left unrivetted for a reason?

Keith R661

____________________________________________________________________________________

Finding fabulous fares is fun.
Let Yahoo! FareChase search your favorite travel sites to find flight and

hotel bargains.

http://farechase.yahoo.com/promo-generic-14795097

-----------------------------------------------------------------
List archives located at: https://mail.dcsol.com/login
username "rebel" password "builder"
Unsubscribe: rebel-builders-unsubscribe@dcsol.com
List administrator: mike.davis@dcsol.com
-----------------------------------------------------------------