murphy-rebel Digest for 7 Jan 2000

[Scott]

Bob, that is exactly the tool I was looking for. I went to Homebase
(can you believe it?) and found one for $12. I'll cut the hole
tomorrow. Thanks.

Scott, In regards to cutting the access holes in the skins, I had =
purchased some time ago a fly type cutter from (Canadian Tire) of all =

After removing the center slug (they may make nice =

washers some day) a quick run around with the deburring tool leaves a =
perfect hole.-Hope this helps-Bob J.

--
Kind Regards

Scott
hibbs@pacifier.com
*----------------------------------------------------*
The Murphy Rebel Builders List is for the discussion
between builders and owners of Murphy Rebel aircraft.
Archives located at:
http://www.dcsol.com/murphy-rebel/lists/default.htm
*----------------------------------------------------*




-----------------------------------------------------------------
List archives located at: https://mail.dcsol.com/login
username "rebel" password "builder"
Unsubscribe: rebel-builders-unsubscribe@dcsol.com
List administrator: mike.davis@dcsol.com
-----------------------------------------------------------------

[Tim Carter]

Scott:

That is the correct tool, and the procedures are correct that Bob
recommends.

Be careful tho, they call it the 'widow-maker' at Boeing. Don't get your
fingers near it when hand-tightening the chuck, stand back, and always wear
safety goggles.

For extra support, especially on the thin .20 wing skins, I always use a 1
ft. sq. plywood backing plate inder the skin.

Tim
#438R

-----Original Message-----
From: Scott [mailto:hibbs@pacifier.com]
Sent: Saturday, January 08, 2000 6:13 AM
To: (Murphy Rebel Builders List)
Subject: Re: murphy-rebel Digest for 7 Jan 2000


Bob, that is exactly the tool I was looking for. I went to Homebase
(can you believe it?) and found one for $12. I'll cut the hole
tomorrow. Thanks.

Scott, In regards to cutting the access holes in the skins, I had =
purchased some time ago a fly type cutter from (Canadian Tire) of all =

After removing the center slug (they may make nice =

washers some day) a quick run around with the deburring tool leaves a =
perfect hole.-Hope this helps-Bob J.

--
Kind Regards

Scott
hibbs@pacifier.com
*----------------------------------------------------*
The Murphy Rebel Builders List is for the discussion
between builders and owners of Murphy Rebel aircraft.
Archives located at:
http://www.dcsol.com/murphy-rebel/lists/default.htm
*----------------------------------------------------*


*----------------------------------------------------*
The Murphy Rebel Builders List is for the discussion
between builders and owners of Murphy Rebel aircraft.
Archives located at:
http://www.dcsol.com/murphy-rebel/lists/default.htm
*----------------------------------------------------*




-----------------------------------------------------------------
List archives located at: https://mail.dcsol.com/login
username "rebel" password "builder"
Unsubscribe: rebel-builders-unsubscribe@dcsol.com
List administrator: mike.davis@dcsol.com
-----------------------------------------------------------------