Page 1 of 1
Engine Controls
Posted: Sat Feb 06, 2016 2:33 pm
by Jerry Folkerts
Does anyone have good locations to cut holes for engine controls through the firewall for a Moose/Super Rebel with a carbureted 0-540? It's time I cut those holes before putting the engine mount etc. on.
Thanks,
Jerry Folkerts
Re: Engine Controls
Posted: Mon Feb 15, 2016 5:07 am
by fadarnell
Jerry,
I ran mine between the two vertical channels and below the horizontal channel. I'm not sure if your firewall is setup like mine so feel free to call if you want to discuss. Nine eight zero seven two two six three five six.
Fred
Re: Engine Controls
Posted: Mon Feb 15, 2016 12:03 pm
by mikeh
Hi Jerry,
I put the engine and mount in position without the firewall and connected the control cables from panel to engine. That way the cables took their natural shape. By measuring the cables positions I could then cut holes in the firewall to suit.
Cheers. Mike.
Re: Engine Controls
Posted: Wed Feb 17, 2016 12:52 pm
by Jerry Folkerts
Thanks guys. Food for thought. Fred, I'll give you a call later this week.
Best,
Jerry