The Murphy Builders Site

Wayne sells the ucs spinners I believe, he could supply all the info

-----Original Message-----
From: mike.davis@dcsol.com [mailto:mike.davis@dcsol.com] On Behalf Of
Rebecca Brownell
Sent: August 14, 2009 9:48 AM
To: rebel-builders@dcsol.com
Subject: [rebel-builders] spinners

Hi all
Trying to figure out my spinner options here.Are those UCS spinners
from spruce any good?Does one usually order them pre cut ?

Thanks,Jason
817R



-----------------------------------------------------------------
List archives located at: https://mail.dcsol.com/login
username "rebel" password "builder"
Unsubscribe: rebel-builders-unsubscribe@dcsol.com
List administrator: mike.davis@dcsol.com
-----------------------------------------------------------------






-----------------------------------------------------------------
List archives located at: https://mail.dcsol.com/login
username "rebel" password "builder"
Unsubscribe: rebel-builders-unsubscribe@dcsol.com
List administrator: mike.davis@dcsol.com
-----------------------------------------------------------------

Jason

I have a UCS spinner on my Rebel and am quite happy with it. They provide
good instruction on how to make the cut out for you prop.

Good luck
Hank Balch 307R

On Fri, Aug 14, 2009 at 9:48 AM, Rebecca Brownell <
brownell@cottagecountry.net> wrote:

Hi all
Trying to figure out my spinner options here.Are those UCS spinners
from spruce any good?Does one usually order them pre cut ?

Thanks,Jason
817R



-----------------------------------------------------------------
List archives located at: https://mail.dcsol.com/login
username "rebel" password "builder"
Unsubscribe: rebel-builders-unsubscribe@dcsol.com
List administrator: mike.davis@dcsol.com
-----------------------------------------------------------------

-----------------------------------------------------------------
List archives located at: https://mail.dcsol.com/login
username "rebel" password "builder"
Unsubscribe: rebel-builders-unsubscribe@dcsol.com
List administrator: mike.davis@dcsol.com
-----------------------------------------------------------------

My first engine had the Murphy metal spinner, but now have the Vans one. It
is much easier to fit and install.

Walter

-----Original Message-----
From: mike.davis@dcsol.com [mailto:mike.davis@dcsol.com] On Behalf Of Hank &
Vickie Balch
Sent: August 14, 2009 4:12 PM
To: rebel-builders@dcsol.com
Subject: Re: [rebel-builders] spinners

Jason

I have a UCS spinner on my Rebel and am quite happy with it. They provide
good instruction on how to make the cut out for you prop.

Good luck
Hank Balch 307R

On Fri, Aug 14, 2009 at 9:48 AM, Rebecca Brownell <
brownell@cottagecountry.net> wrote:

Hi all
Trying to figure out my spinner options here.Are those UCS spinners
from spruce any good?Does one usually order them pre cut ?

Thanks,Jason
817R



-----------------------------------------------------------------
List archives located at: https://mail.dcsol.com/login
username "rebel" password "builder"
Unsubscribe: rebel-builders-unsubscribe@dcsol.com
List administrator: mike.davis@dcsol.com
-----------------------------------------------------------------

-----------------------------------------------------------------
List archives located at: https://mail.dcsol.com/login
username "rebel" password "builder"
Unsubscribe: rebel-builders-unsubscribe@dcsol.com
List administrator: mike.davis@dcsol.com
-----------------------------------------------------------------






-----------------------------------------------------------------
List archives located at: https://mail.dcsol.com/login
username "rebel" password "builder"
Unsubscribe: rebel-builders-unsubscribe@dcsol.com
List administrator: mike.davis@dcsol.com
-----------------------------------------------------------------