[SPAM][rebel-builders] float sealant removal
Posted: Sun Feb 19, 2012 5:25 pm
Good tip, Ken. I'll use that one. A good piece of hardwood will work the
best.
On another note, everyone if you haven't already done so, disregard my post
where I was lamenting about remaking the pieces due to moving my firewall
back. I decided to put it back. No, seriously I realized today that I can
lop off the front end of the remaining pcs and keep the aft end as is with
existing holes. When I initially cut the panel back it changed the angle of
the sides and the old piece wouldn't work. I assumed (I know) that the
others would be trouble as well. Well, they're not and life is good again.
Craig
-----------------------------------------------------------------
List archives located at: https://mail.dcsol.com/login
username "rebel" password "builder"
Unsubscribe: rebel-builders-unsubscribe@dcsol.com
List administrator: mike.davis@dcsol.com
-----------------------------------------------------------------
best.
On another note, everyone if you haven't already done so, disregard my post
where I was lamenting about remaking the pieces due to moving my firewall
back. I decided to put it back. No, seriously I realized today that I can
lop off the front end of the remaining pcs and keep the aft end as is with
existing holes. When I initially cut the panel back it changed the angle of
the sides and the old piece wouldn't work. I assumed (I know) that the
others would be trouble as well. Well, they're not and life is good again.
Craig
-----------------------------------------------------------------
List archives located at: https://mail.dcsol.com/login
username "rebel" password "builder"
Unsubscribe: rebel-builders-unsubscribe@dcsol.com
List administrator: mike.davis@dcsol.com
-----------------------------------------------------------------