New issue FUS-30 thickness and FUS-30 doubler
Posted: Sun Feb 19, 2012 5:24 pm
Hi All,
Just getting ready to close up the tail cone/ fin area and wanted to clear up
one last thing before doing so. Since my kit #786 came with a 0.032" FUS-30
wrap (I believe the old ones were 0.020"), I assumed an additional FUS-30
reinforcement was superfluous. Is this a correct assumption, or is the group
advocating bringing this area to a bullet-stopping 0.064"? The current FUS-
30 was a nightmare to wrangle to the right shape...I can't imagine two of
these on top of each other.
Rob
Rebel 786
-----------------------------------------------------------------
List archives located at: https://mail.dcsol.com/login
username "rebel" password "builder"
Unsubscribe: rebel-builders-unsubscribe@dcsol.com
List administrator: mike.davis@dcsol.com
-----------------------------------------------------------------
Just getting ready to close up the tail cone/ fin area and wanted to clear up
one last thing before doing so. Since my kit #786 came with a 0.032" FUS-30
wrap (I believe the old ones were 0.020"), I assumed an additional FUS-30
reinforcement was superfluous. Is this a correct assumption, or is the group
advocating bringing this area to a bullet-stopping 0.064"? The current FUS-
30 was a nightmare to wrangle to the right shape...I can't imagine two of
these on top of each other.
Rob
Rebel 786
-----------------------------------------------------------------
List archives located at: https://mail.dcsol.com/login
username "rebel" password "builder"
Unsubscribe: rebel-builders-unsubscribe@dcsol.com
List administrator: mike.davis@dcsol.com
-----------------------------------------------------------------