Page 1 of 1
Drilling holes strut
Posted: Sun Feb 19, 2012 5:20 pm
by Mike Betti
I was wondering if anyone had a problem with drilling and tapping 2 AN3
holes in the top of my Elite wing strut, about
Drilling holes strut
Posted: Sun Feb 19, 2012 5:20 pm
by Ralph Baker
Mike,
If the good denizens of the Rebel List dont have a scrap of strut to trace here are two alternates. The machinist supply houses have a tool that has many small wires in a holder that allows the wires to take the form of objects it is pressed against. That allows duplication of the contour. Another option would be to hold a piece of rough (80) sandpaper tightly on the strut and sand a block of foam to the correct contour.
Ralph Baker
-----------------------------------------------------------------
List archives located at:
https://mail.dcsol.com/login
username "rebel" password "builder"
Unsubscribe:
rebel-builders-unsubscribe@dcsol.com
List administrator:
mike.davis@dcsol.com
-----------------------------------------------------------------