[rebel-builders] too quiet: allen key debur tool
Posted: Sun Feb 19, 2012 5:16 pm
Here it is: http://mae.ucdavis.edu/ransom/Murphy/mi ... urTool.jpg
next to a #30 drill. Also, I just measured the allen wrench and it is a
metric #2. The tape on the "shaft" has an ink mark on one side as
mentioned in the original post.
On 2/21/2009 6:38 AM, jasthompson@sympatico.ca wrote to rebel-builders:
-----------------------------------------------------------------
List archives located at: https://mail.dcsol.com/login
username "rebel" password "builder"
Unsubscribe: rebel-builders-unsubscribe@dcsol.com
List administrator: mike.davis@dcsol.com
-----------------------------------------------------------------
next to a #30 drill. Also, I just measured the allen wrench and it is a
metric #2. The tape on the "shaft" has an ink mark on one side as
mentioned in the original post.
On 2/21/2009 6:38 AM, jasthompson@sympatico.ca wrote to rebel-builders:
Maybe I'm too dyslexic too visualize your contraption. A photo or two of it
would be great!
J. Alan Thompson
-----------------------------------------------------------------
List archives located at: https://mail.dcsol.com/login
username "rebel" password "builder"
Unsubscribe: rebel-builders-unsubscribe@dcsol.com
List administrator: mike.davis@dcsol.com
-----------------------------------------------------------------