[rebel-builders] spinner/cowl clearance
Posted: Sun Feb 19, 2012 5:15 pm
AC43.13 says 1/2" minimum. An inch is better.
On Feb 15, 2009, at 10:12 AM, "Tim Saxton" <tim.saxton@shaw.ca> wrote:
-----------------------------------------------------------------
List archives located at: https://mail.dcsol.com/login
username "rebel" password "builder"
Unsubscribe: rebel-builders-unsubscribe@dcsol.com
List administrator: mike.davis@dcsol.com
-----------------------------------------------------------------
On Feb 15, 2009, at 10:12 AM, "Tim Saxton" <tim.saxton@shaw.ca> wrote:
The spinner I have for my IO-540 engine has a backing plate which
attaches to the starting ring. I have to trim the forward cowl to
allow for clearance of the spinner backing plate. How much extra
clearance should I allow for engine movement? i.e. how much does the
forward engine move during starting/stopping, firm landings...?
Tim
SR060
-----------------------------------------------------------------
List archives located at: https://mail.dcsol.com/login
username "rebel" password "builder"
Unsubscribe: rebel-builders-unsubscribe@dcsol.com
List administrator: mike.davis@dcsol.com
-----------------------------------------------------------------
-----------------------------------------------------------------
List archives located at: https://mail.dcsol.com/login
username "rebel" password "builder"
Unsubscribe: rebel-builders-unsubscribe@dcsol.com
List administrator: mike.davis@dcsol.com
-----------------------------------------------------------------