[rebel-builders] Parts do not fit
Posted: Sun Feb 19, 2012 5:07 pm
Hi Roger
Hope you're all keeping well in Chicago ?
When I did mine they did fit OK but I seem to remember only one way. It
looks square but it isn't so I didn't need to file it down at all when I
figured it out (although it seems a lifetime ago now it was only a couple of
years ago !!) :-)
Nig
745E
Still building :-)
-----Original Message-----
From: mike.davis@dcsol.com [mailto:mike.davis@dcsol.com] On Behalf Of Roger
Cole
Sent: 12 December 2008 21:51
To: Rebel Builders
Subject: [rebel-builders] Parts do not fit
Instruction 9.23.9 says "Align the FUS-86 part inside the FUS-85
bracket, then mark and trim off the end of FUS-85 as shown." The
problem is that the FUS-86 is 1-inch thick, and the inside width of
FUS-85 is 15/16 inch. FUS-86 does not fit inside FUS-85. Should I
machine 1/32 inch off each side of the FUS-86?
Roger Cole
Murphy Elite #709
rcole927@earthlink.net
-----------------------------------------------------------------
List archives located at: https://mail.dcsol.com/login
username "rebel" password "builder"
Unsubscribe: rebel-builders-unsubscribe@dcsol.com
List administrator: mike.davis@dcsol.com
-----------------------------------------------------------------
-----------------------------------------------------------------
List archives located at: https://mail.dcsol.com/login
username "rebel" password "builder"
Unsubscribe: rebel-builders-unsubscribe@dcsol.com
List administrator: mike.davis@dcsol.com
-----------------------------------------------------------------
Hope you're all keeping well in Chicago ?
When I did mine they did fit OK but I seem to remember only one way. It
looks square but it isn't so I didn't need to file it down at all when I
figured it out (although it seems a lifetime ago now it was only a couple of
years ago !!) :-)
Nig
745E
Still building :-)
-----Original Message-----
From: mike.davis@dcsol.com [mailto:mike.davis@dcsol.com] On Behalf Of Roger
Cole
Sent: 12 December 2008 21:51
To: Rebel Builders
Subject: [rebel-builders] Parts do not fit
Instruction 9.23.9 says "Align the FUS-86 part inside the FUS-85
bracket, then mark and trim off the end of FUS-85 as shown." The
problem is that the FUS-86 is 1-inch thick, and the inside width of
FUS-85 is 15/16 inch. FUS-86 does not fit inside FUS-85. Should I
machine 1/32 inch off each side of the FUS-86?
Roger Cole
Murphy Elite #709
rcole927@earthlink.net
-----------------------------------------------------------------
List archives located at: https://mail.dcsol.com/login
username "rebel" password "builder"
Unsubscribe: rebel-builders-unsubscribe@dcsol.com
List administrator: mike.davis@dcsol.com
-----------------------------------------------------------------
-----------------------------------------------------------------
List archives located at: https://mail.dcsol.com/login
username "rebel" password "builder"
Unsubscribe: rebel-builders-unsubscribe@dcsol.com
List administrator: mike.davis@dcsol.com
-----------------------------------------------------------------