motor mount -320
Posted: Sun Feb 19, 2012 5:03 pm
I'm ready to install Wayne's firewall reinforcing plates, but don't yet
have a motor mount. So, I don't know where to avoid putting rivets. Does
anyone have a photo that would show 0320 motor mount location well enf that
I could lay out the holes and stay clear? And, are the dynafocal and
conical motor mounts different in where they bolt onto the firewall?
Another piece of this is that although 0320 is my likely choice, I'm
holding off committing to any particular engine till I'm really ready for
engine installation -- probably a year away even if I'm lucky. I'd like to
get these plates on though, at least most holes/rivets.
-----------------------------------------------------------------
List archives located at: https://mail.dcsol.com/login
username "rebel" password "builder"
Unsubscribe: rebel-builders-unsubscribe@dcsol.com
List administrator: mike.davis@dcsol.com
-----------------------------------------------------------------
have a motor mount. So, I don't know where to avoid putting rivets. Does
anyone have a photo that would show 0320 motor mount location well enf that
I could lay out the holes and stay clear? And, are the dynafocal and
conical motor mounts different in where they bolt onto the firewall?
Another piece of this is that although 0320 is my likely choice, I'm
holding off committing to any particular engine till I'm really ready for
engine installation -- probably a year away even if I'm lucky. I'd like to
get these plates on though, at least most holes/rivets.
-----------------------------------------------------------------
List archives located at: https://mail.dcsol.com/login
username "rebel" password "builder"
Unsubscribe: rebel-builders-unsubscribe@dcsol.com
List administrator: mike.davis@dcsol.com
-----------------------------------------------------------------