The Murphy Builders Site

Hi Jason !

I recall on the old original, the suggested method was to
form them over a sandbag or shot-bag, using a rubber mallet...

In later days, using a shrinker-stretcher was the preferred
method - good time to learn how to use this tool !

Practice on scrap aluminum - it's easy to mess up the
surface .... Carmon might have one you could borrow -
they're about $300+ to buy ... (You'll need one for floats ..)

--
......bobp
bobp@prosumers.ca
http://www.prosumers.ca/Ramble09

http://bpatterson.qhealthbeauty.com
http://apatterson2.qhealthzone.com
http://apatterson2.ordermygift.com

-------------------------------orig.-------------------------
On Saturday 08 November 2008 16:15, Rebecca Brownell wrote:

Hi all
Having a deuce of a time trying to get the wraps between bulkhead A
and F bent properly to make the transition from the cabin
to the tail cone.Any helpful tricks out there?Any help would be
appreciated.
Thanks
Jason
817R

-----------------------------------------------------------------
List archives located at: https://mail.dcsol.com/login
username "rebel" password "builder"
Unsubscribe: rebel-builders-unsubscribe@dcsol.com
List administrator: mike.davis@dcsol.com
-----------------------------------------------------------------