The Murphy Builders Site

Hi all
Having a deuce of a time trying to get the wraps between bulkhead A
and F bent properly to make the transition from the cabin
to the tail cone.Any helpful tricks out there?Any help would be
appreciated.
Thanks
Jason
817R



-----------------------------------------------------------------
List archives located at: https://mail.dcsol.com/login
username "rebel" password "builder"
Unsubscribe: rebel-builders-unsubscribe@dcsol.com
List administrator: mike.davis@dcsol.com
-----------------------------------------------------------------

Hi Jason
I used the wood cutout per MAM, and hit it with a rounded dolly. I marked a
line about 3/4" in from the end, on the inside of the wrap to keep track of
where I was hammering. Chamfer the edge of the wood form to avoid hammering
sharp lines in the wrap.
If helpful, some pictures at:
http://mae.ucdavis.edu/ransom/Murphy/20 ... 5/0805.htm

Cheers,
-Ben/ 496R

Hi all
Having a deuce of a time trying to get the wraps between bulkhead A
and F bent properly to make the transition from the cabin
to the tail cone.Any helpful tricks out there?Any help would be
appreciated.
Thanks
Jason
817R

-----------------------------------------------------------------
List archives located at: https://mail.dcsol.com/login
username "rebel" password "builder"
Unsubscribe: rebel-builders-unsubscribe@dcsol.com
List administrator: mike.davis@dcsol.com
-----------------------------------------------------------------