firewall angle and fitting
Posted: Sun Feb 19, 2012 4:56 pm
I'm trying to fit the firewall with side panels (Fus-11 L&R) and floor skin
(Fus-7). The flexibility of the firewall allows for a pretty variable
result here. I want to add some stiffeners to the firewall so I know it is
flat as I set the firewall angle and final length of the floor skin.
One possibility is to go ahead and cut the witches hat lengths and cleco
them on now. As well I could spring clamp on some ST-31 or similar.
Have others found this a good idea? I can't imagine any problems from
cutting and clecoing the witches hat on at time of firewall fitting
...appreciate any advice on that approach too.
Thanks,
-Ben/ 496R
-----------------------------------------------------------------
List archives located at: https://mail.dcsol.com/login
username "rebel" password "builder"
Unsubscribe: rebel-builders-unsubscribe@dcsol.com
List administrator: mike.davis@dcsol.com
-----------------------------------------------------------------
(Fus-7). The flexibility of the firewall allows for a pretty variable
result here. I want to add some stiffeners to the firewall so I know it is
flat as I set the firewall angle and final length of the floor skin.
One possibility is to go ahead and cut the witches hat lengths and cleco
them on now. As well I could spring clamp on some ST-31 or similar.
Have others found this a good idea? I can't imagine any problems from
cutting and clecoing the witches hat on at time of firewall fitting
...appreciate any advice on that approach too.
Thanks,
-Ben/ 496R
-----------------------------------------------------------------
List archives located at: https://mail.dcsol.com/login
username "rebel" password "builder"
Unsubscribe: rebel-builders-unsubscribe@dcsol.com
List administrator: mike.davis@dcsol.com
-----------------------------------------------------------------