[rebel-builders] R Fuselage interr floor tie downs
Posted: Sun Feb 19, 2012 4:52 pm
Hi Charlie
I fitted the domed tie down points from Vans through the floor into clipnuts
on the ribs under the floor.
http://www.vansaircraft.com/cgi-bin/cat ... 64-585&bro
wse=airframe&product=tie-down
I've acquired loads of the rings you clip into them when needed, clip nuts,
and 10/32 machine screws, so drop us a line if you want some and I'll drop
them in the post
Nigel (nigel@airnig.co.uk)
745E
-----Original Message-----
From: mike.davis@dcsol.com [mailto:mike.davis@dcsol.com] On Behalf Of
Charlie Eubanks
Sent: 03 September 2008 23:08
To: rebel-builders@dcsol.com
Subject: [rebel-builders] R Fuselage interr floor
Hello Group
Finally got the inter-floor and corner raps of the rear fuselage all
fabricated and ready to rivet. I would like to install a few tie down rings
and was wondering what kind you would recommend and where I can get them? I
would appreciate any help or suggestions.
Charlie E. 802R
-----------------------------------------------------------------
List archives located at: https://mail.dcsol.com/login
username "rebel" password "builder"
Unsubscribe: rebel-builders-unsubscribe@dcsol.com
List administrator: mike.davis@dcsol.com
-----------------------------------------------------------------
-----------------------------------------------------------------
List archives located at: https://mail.dcsol.com/login
username "rebel" password "builder"
Unsubscribe: rebel-builders-unsubscribe@dcsol.com
List administrator: mike.davis@dcsol.com
-----------------------------------------------------------------
I fitted the domed tie down points from Vans through the floor into clipnuts
on the ribs under the floor.
http://www.vansaircraft.com/cgi-bin/cat ... 64-585&bro
wse=airframe&product=tie-down
I've acquired loads of the rings you clip into them when needed, clip nuts,
and 10/32 machine screws, so drop us a line if you want some and I'll drop
them in the post
Nigel (nigel@airnig.co.uk)
745E
-----Original Message-----
From: mike.davis@dcsol.com [mailto:mike.davis@dcsol.com] On Behalf Of
Charlie Eubanks
Sent: 03 September 2008 23:08
To: rebel-builders@dcsol.com
Subject: [rebel-builders] R Fuselage interr floor
Hello Group
Finally got the inter-floor and corner raps of the rear fuselage all
fabricated and ready to rivet. I would like to install a few tie down rings
and was wondering what kind you would recommend and where I can get them? I
would appreciate any help or suggestions.
Charlie E. 802R
-----------------------------------------------------------------
List archives located at: https://mail.dcsol.com/login
username "rebel" password "builder"
Unsubscribe: rebel-builders-unsubscribe@dcsol.com
List administrator: mike.davis@dcsol.com
-----------------------------------------------------------------
-----------------------------------------------------------------
List archives located at: https://mail.dcsol.com/login
username "rebel" password "builder"
Unsubscribe: rebel-builders-unsubscribe@dcsol.com
List administrator: mike.davis@dcsol.com
-----------------------------------------------------------------