The Murphy Builders Site

Received: from MMoreho699@aol.com
by imo17.mx.aol.com (IMOv14.1) id GPWEa21163;
Tue, 5 May 1998 13:39:48 -0400 (EDT)
From: MMoreho699 <MMoreho699@aol.com>
Message-ID: <d550cce.354f4ee5@aol.com>
Date: Tue, 5 May 1998 13:39:48 EDT
To: murphy-rebel@dcsol.com
Cc: murtech@murphyair.com
Mime-Version: 1.0
Subject: 3/32" rivets for tailcone inner floor
Content-type: text/plain; charset=US-ASCII
Content-transfer-encoding: 7bit
X-Mailer: AOL 2.7 for Mac sub 3

Hello!

Just putting the finnishing touches on the inner floor. I don't plan on
riveting since I might need access later for wiring or FAA inspection.

While I was placing the rolled corners I found that the inner flange of the
bulkhead corners were much narrower than the straight parts. Except for one
odd wide flange, there is not enough room for 1/8" rivets there. I was
thinking of smaller rivets or not doing them at all.

Also I messed up during the overlap where one rolled corner ends and the
other
begins. I wanted to rivet the two pieces to these skinny bulkhead corners,
but
somehow botched aligning the holes. So I elected to extend the overlap a
little and make a second row of rivets that fastens only the rolled corners
themselves without being secured to the bulkhead. I figured this would be
okay
since it's not bearing much of a load.

Comments?

Thanks,
Dan



-----------------------------------------------------------------
List archives located at: https://mail.dcsol.com/login
username "rebel" password "builder"
Unsubscribe: rebel-builders-unsubscribe@dcsol.com
List administrator: mike.davis@dcsol.com
-----------------------------------------------------------------