The Murphy Builders Site

Hi Ben !

Not sure it really matters ..... certainly looks OK
this way, and can't remember EVER seeing one OVER
the FUS-26 -- but I'm no expert.

The pic reminded me, though, that one Ontario mod
is to increase FUS-26 to .032 or .040, and add a vertical
channel or 2 behind it - or pieces of stringer..
Also, if you have a choice, it would be better to use
FUS-70's (.025) for ALL of the 8 corner wraps ....
might save some grief later.

--
......bobp
bobp@prosumers.ca
http://www.prosumers.ca/Ramble08

http://bpatterson.qhealthbeauty.com
http://apatterson2.qhealthzone.com
http://apatterson2.ordermygift.com

-------------------------------orig.-------------------------
On Friday 08 August 2008 02:26, bransom@dcsol.com wrote:

I'm trying to figure out what the correct (best?) overlap is on the
tapered corner wrap with Fuse-26 and Fus-25 below the door sill area.
Here's a photo from the Rebel CD to make my question easier to understand.
<a
href="http://mae.ucdavis.edu/ransom/Murphy/20 ... /mae.ucdav
is.edu/ransom/Murphy/2008/fuse.jpg</a>

In this the tapered corner wrap is underneath, then the triangle Fus-25,
then the rectangle Fus-26 is outermost. Is this the best way, or have
some found a better layering order?
Thanks,
-Ben/ 496R

-----------------------------------------------------------------
List archives located at: https://mail.dcsol.com/login
username "rebel" password "builder"
Unsubscribe: rebel-builders-unsubscribe@dcsol.com
List administrator: mike.davis@dcsol.com
-----------------------------------------------------------------