1800 Amphib question
Posted: Sun Feb 19, 2012 4:43 pm
At one time I talked to someone or read about machining FL230 pivot block on the front gear 2 or 3 degrees to give the pivot shaft a negative angle. I sure would like any input I could get on this. Thanks in advance.
Si
-----------------------------------------------------------------
List archives located at: https://mail.dcsol.com/login
username "rebel" password "builder"
Unsubscribe: rebel-builders-unsubscribe@dcsol.com
List administrator: mike.davis@dcsol.com
-----------------------------------------------------------------
Si
-----------------------------------------------------------------
List archives located at: https://mail.dcsol.com/login
username "rebel" password "builder"
Unsubscribe: rebel-builders-unsubscribe@dcsol.com
List administrator: mike.davis@dcsol.com
-----------------------------------------------------------------