Nicropress: Answering my own question
Posted: Sun Feb 19, 2012 4:31 pm
Looking at AC 43.13-1B, Table 7-6, page 7-34:
Says there that one should use part # 28-3-M (req'd on stainless cables due
to electrolysis). Initial length is 9/16" which matches the blank sleeves
that I have already.
The only thing I don't know is whether the sleeves I have now are 18-3-M or
28-3-M. Probably should order new ones just to make sure.<sigh> another ACS
order.
Ted
-----------------------------------------------------------------
List archives located at: https://mail.dcsol.com/login
username "rebel" password "builder"
Unsubscribe: rebel-builders-unsubscribe@dcsol.com
List administrator: mike.davis@dcsol.com
-----------------------------------------------------------------
Says there that one should use part # 28-3-M (req'd on stainless cables due
to electrolysis). Initial length is 9/16" which matches the blank sleeves
that I have already.
The only thing I don't know is whether the sleeves I have now are 18-3-M or
28-3-M. Probably should order new ones just to make sure.<sigh> another ACS
order.
Ted
-----------------------------------------------------------------
List archives located at: https://mail.dcsol.com/login
username "rebel" password "builder"
Unsubscribe: rebel-builders-unsubscribe@dcsol.com
List administrator: mike.davis@dcsol.com
-----------------------------------------------------------------