The Murphy Builders Site

Hi Jean: Ralph is right about extrusions being done for Murphy, however I
have been able to find round and square aluminum tubing in stock from a
place called Metal Supermarket. This is a chain of stores. You may not be
able to get the 6061-t6 with radius outside corners but other grades are
available. So I guess it is depending on your application. Bob J

-----Original Message-----
From: mike.davis@dcsol.com [mailto:mike.davis@dcsol.com] On Behalf Of Jean
Poirier
Sent: February-13-08 11:34 AM
To: rebel-builders@dcsol.com
Subject: [rebel-builders] Aluminium tube...

Someone have a source in Canada for 5/8

Hum...

My plan was to use it to make a floor doubler under the rudder/brake pedal
area. May be I have an other option:
__
1- form with the box/brake or the press some "hats" __| |__

Jean
Rebel 747R



Jean Poirier
Pr

I just made the called for .032 doubler bigger so that it's captured by the
firewall and the corner wraps / centre stiffener. It's working well so far.

At 04:13 PM 2/13/2008 -0500, you wrote:
[quote]Hum...

My plan was to use it to make a floor doubler under the rudder/brake pedal
area. May be I have an other option:
__
1- form with the box/brake or the press some "hats" __| |__

Jean
Rebel 747R



Jean Poirier
Pr

__
__|

or
__ __
|___|

also works Jean. That will also hold some 1/4" plywood down if you want
a wear floor for your feet. Or just an angle |__

Even without floor mounted brake cylinders, I agree that it is probably
a good idea to install something about 1/2" high fore and aft to
stabilize the lower engine mounts.

Ken

Jean Poirier wrote:

Hum...

My plan was to use it to make a floor doubler under the rudder/brake pedal
area. May be I have an other option:
__
1- form with the box/brake or the press some "hats" __| |__

Jean
Rebel 747R

-----------------------------------------------------------------
List archives located at: https://mail.dcsol.com/login
username "rebel" password "builder"
Unsubscribe: rebel-builders-unsubscribe@dcsol.com
List administrator: mike.davis@dcsol.com
-----------------------------------------------------------------