Rebel landing gear...
Posted: Sun Feb 19, 2012 4:21 pm
Hello
On the lower slide tube, manual say to rivet #30 and drill #11 holes to 5/16"... but on drawing and 15.3.6 they show 3/8" bolts... on the
same drawing, they show the safety cable down to bottom of tube but earlier they make it shorter to be fix by the bolt on the center of the
tube....? %$/?$/"%&$%& manua... If it is all 3/8" bolts, my inventory is short of 3/8" bolts... but later for the bungees, they show 5/16"
bolts.... $?%?"% manual So If I have a 3/8" bolt on top and a 5/16" in the middle, is anything wrong?
Jean
Rebel 747Rl
-----------------------------------------------------------------
List archives located at: https://mail.dcsol.com/login
username "rebel" password "builder"
Unsubscribe: rebel-builders-unsubscribe@dcsol.com
List administrator: mike.davis@dcsol.com
-----------------------------------------------------------------
On the lower slide tube, manual say to rivet #30 and drill #11 holes to 5/16"... but on drawing and 15.3.6 they show 3/8" bolts... on the
same drawing, they show the safety cable down to bottom of tube but earlier they make it shorter to be fix by the bolt on the center of the
tube....? %$/?$/"%&$%& manua... If it is all 3/8" bolts, my inventory is short of 3/8" bolts... but later for the bungees, they show 5/16"
bolts.... $?%?"% manual So If I have a 3/8" bolt on top and a 5/16" in the middle, is anything wrong?
Jean
Rebel 747Rl
-----------------------------------------------------------------
List archives located at: https://mail.dcsol.com/login
username "rebel" password "builder"
Unsubscribe: rebel-builders-unsubscribe@dcsol.com
List administrator: mike.davis@dcsol.com
-----------------------------------------------------------------