a little question...
Posted: Sun Feb 19, 2012 4:17 pm
Fuselage almost done, the inside floor ready to be riveted but not done yet
(another inspection... bofore closing). The tail is sit on cushion (old aircraft
tire!) and the cabin is sit on landing gear brachets (still on table). If I put
plywood inside the airplane, everything is strong enough to go in and do small
work? instead of trying to be the next Sun Circus "rubber man"!
Jean
Rebel 747R
-----------------------------------------------------------------
List archives located at: https://mail.dcsol.com/login
username "rebel" password "builder"
Unsubscribe: rebel-builders-unsubscribe@dcsol.com
List administrator: mike.davis@dcsol.com
-----------------------------------------------------------------
(another inspection... bofore closing). The tail is sit on cushion (old aircraft
tire!) and the cabin is sit on landing gear brachets (still on table). If I put
plywood inside the airplane, everything is strong enough to go in and do small
work? instead of trying to be the next Sun Circus "rubber man"!
Jean
Rebel 747R
-----------------------------------------------------------------
List archives located at: https://mail.dcsol.com/login
username "rebel" password "builder"
Unsubscribe: rebel-builders-unsubscribe@dcsol.com
List administrator: mike.davis@dcsol.com
-----------------------------------------------------------------