Page 1 of 1

[rebel-builders] wing attach brackets...

Posted: Sun Feb 19, 2012 4:17 pm
by Wayne G. O'Shea
Trim TWO brackets for EACH side Jean....and then a full size one goes on
each side of them for a total of FOUR on each side. This is where the rear
wing attach fitting will slide INTO these fuselage fittings.

Wayne

----- Original Message -----
From: <jean.poirier@oxyportneuf.com>
To: <rebel-builders@dcsol.com>
Sent: Wednesday, January 02, 2008 2:46 PM
Subject: [rebel-builders] wing attach brackets...

Hello

Manual ask to trim ( fuselage-69) the "two inner brackets" as in
figure12.26.3 Is that mean one on each side (right and left wing) or
two on
each side. Also, "inner fittings" is that mean the ones on the door side
(not on the tail side)? As you see my english is far from perfect and
I
am not sure if I understand well what the manual ask for

Thanks

Jean
Rebel 747R





-----------------------------------------------------------------
List archives located at: https://mail.dcsol.com/login
username "rebel" password "builder"
Unsubscribe: rebel-builders-unsubscribe@dcsol.com
List administrator: mike.davis@dcsol.com
-----------------------------------------------------------------






-----------------------------------------------------------------
List archives located at: https://mail.dcsol.com/login
username "rebel" password "builder"
Unsubscribe: rebel-builders-unsubscribe@dcsol.com
List administrator: mike.davis@dcsol.com
-----------------------------------------------------------------

[rebel-builders] wing attach brackets...

Posted: Sun Feb 19, 2012 4:17 pm
by jean.poirier
Hello Wayne

Thank you very much!

Have a very good year. Good health to you and to all of your famiily.

Thanks again

Jean

On Wed Jan 2 14:52 , 'Wayne G. O'Shea' <oifa@irishfield.on.ca> sent:
Trim TWO brackets for EACH side Jean....and then a full size one goes on
each side of them for a total of FOUR on each side. This is where the rear
wing attach fitting will slide INTO these fuselage fittings.

Wayne

----- Original Message -----
From: jean.poirier@oxyportneuf.com>
To: rebel-builders@dcsol.com>
Sent: Wednesday, January 02, 2008 2:46 PM
Subject: [rebel-builders] wing attach brackets...

Hello

Manual ask to trim ( fuselage-69) the "two inner brackets" as in
figure12.26.3 Is that mean one on each side (right and left wing) or
two on
each side. Also, "inner fittings" is that mean the ones on the door side
(not on the tail side)? As you see my english is far from perfect and
I
am not sure if I understand well what the manual ask for

Thanks

Jean
Rebel 747R





-----------------------------------------------------------------
List archives located at: https://mail.dcsol.com/login
username "rebel" password "builder"
Unsubscribe: rebel-builders-unsubscribe@dcsol.com
List administrator: mike.davis@dcsol.com
-----------------------------------------------------------------






-----------------------------------------------------------------
List archives located at: https://mail.dcsol.com/login
username "rebel" password "builder"
Unsubscribe: rebel-builders-unsubscribe@dcsol.com
List administrator: mike.davis@dcsol.com
-----------------------------------------------------------------






-----------------------------------------------------------------
List archives located at: https://mail.dcsol.com/login
username "rebel" password "builder"
Unsubscribe: rebel-builders-unsubscribe@dcsol.com
List administrator: mike.davis@dcsol.com
-----------------------------------------------------------------