The Murphy Builders Site

Guys,

For the few of you out there who are building the
stock rudder pedals from Murphy: (oh, and I am
referencing the latest drawings from Chapter 12 of the
manual that can be downloaded from Murphy's tech
support site - dated 21/08/2007)

1) I assume the "master torque fitting - RP0019" is
supposed to be press fitted onto the end of the "slave
brake torque tube - RP0018"? Has anyone added a rivet
here?

2) I am confused on the parts list, page 3 of the
21/08/2007 rudder pedal parts list page. Item 14 lists
qty 40 of AN960-10 and 12 cotter pins MS24665-132? Is
this a type-o? I don't understand where these parts
go?

3) I can't find reference to the master cylinder
standoffs, BRK0220 in my parts listing. Are these to
be fabricated from raw stock, and if so which one?

Thanks, -Jason


____________________________________________________________________________________
Be a better friend, newshound, and
know-it-all with Yahoo! Mobile. Try it now. http://mobile.yahoo.com/;_ylt=Ahu06i62s ... o8Wcj9tAcJ




-----------------------------------------------------------------
List archives located at: https://mail.dcsol.com/login
username "rebel" password "builder"
Unsubscribe: rebel-builders-unsubscribe@dcsol.com
List administrator: mike.davis@dcsol.com
-----------------------------------------------------------------