Moose seat back welds
Posted: Sun Feb 19, 2012 4:17 pm
Hi folks,
I am at section 22.2, instruction #4, of the
manual(Figure 22.2.5). The seat frame welds where the
horizontal and diagonal members of the seat frame meet
(where the hole is supposed to be drilled to mount the
seat back frame to the seat base frame) interfere with
mounting. I am hesitant to grind these welds down for
fear of weakening the frame. Anyone have any ideas, or
delt with this problem?
Thanks, -Jason
____________________________________________________________________________________
Never miss a thing. Make Yahoo your home page.
http://www.yahoo.com/r/hs
-----------------------------------------------------------------
List archives located at: https://mail.dcsol.com/login
username "rebel" password "builder"
Unsubscribe: rebel-builders-unsubscribe@dcsol.com
List administrator: mike.davis@dcsol.com
-----------------------------------------------------------------
I am at section 22.2, instruction #4, of the
manual(Figure 22.2.5). The seat frame welds where the
horizontal and diagonal members of the seat frame meet
(where the hole is supposed to be drilled to mount the
seat back frame to the seat base frame) interfere with
mounting. I am hesitant to grind these welds down for
fear of weakening the frame. Anyone have any ideas, or
delt with this problem?
Thanks, -Jason
____________________________________________________________________________________
Never miss a thing. Make Yahoo your home page.
http://www.yahoo.com/r/hs
-----------------------------------------------------------------
List archives located at: https://mail.dcsol.com/login
username "rebel" password "builder"
Unsubscribe: rebel-builders-unsubscribe@dcsol.com
List administrator: mike.davis@dcsol.com
-----------------------------------------------------------------