rivet corner (edge?) distance
Posted: Fri Feb 17, 2012 4:21 pm
Received: from MMoreho699@aol.com
by imo13.mx.aol.com (IMOv14.1) id PUUKa02378;
Mon, 27 Apr 1998 02:28:40 -0400 (EDT)
From: MMoreho699 <MMoreho699@aol.com>
Message-ID: <f41d8f0b.3544259b@aol.com>
Date: Mon, 27 Apr 1998 02:28:40 EDT
To: murtech@murphyair.com, murphy-rebel@dcsol.com
Mime-Version: 1.0
Subject: rivet corner (edge?) distance
Content-type: text/plain; charset=US-ASCII
Content-transfer-encoding: 7bit
X-Mailer: AOL 3.0 for Mac sub 84
Hello!
Finally got the wings hung up at the top of the garage. Now I'm finishing
the
float hardpoint installation. There is a set of four 90 degree angle corner
brackets that I rivetted together. Then I made a nested set of only two to
support the floats. I've come close to the corner of the flange on a few
rivets. If I had made a hole too far the other way I would have been too
close
to the edge. So what is the rule for 'corner distance'? Same as for edge?
Measure to inside or outside of the curve, or where it starts to bend or
what?
Hoping you know what I mean and will punch my ticket,
Dan
-----------------------------------------------------------------
List archives located at: https://mail.dcsol.com/login
username "rebel" password "builder"
Unsubscribe: rebel-builders-unsubscribe@dcsol.com
List administrator: mike.davis@dcsol.com
-----------------------------------------------------------------
by imo13.mx.aol.com (IMOv14.1) id PUUKa02378;
Mon, 27 Apr 1998 02:28:40 -0400 (EDT)
From: MMoreho699 <MMoreho699@aol.com>
Message-ID: <f41d8f0b.3544259b@aol.com>
Date: Mon, 27 Apr 1998 02:28:40 EDT
To: murtech@murphyair.com, murphy-rebel@dcsol.com
Mime-Version: 1.0
Subject: rivet corner (edge?) distance
Content-type: text/plain; charset=US-ASCII
Content-transfer-encoding: 7bit
X-Mailer: AOL 3.0 for Mac sub 84
Hello!
Finally got the wings hung up at the top of the garage. Now I'm finishing
the
float hardpoint installation. There is a set of four 90 degree angle corner
brackets that I rivetted together. Then I made a nested set of only two to
support the floats. I've come close to the corner of the flange on a few
rivets. If I had made a hole too far the other way I would have been too
close
to the edge. So what is the rule for 'corner distance'? Same as for edge?
Measure to inside or outside of the curve, or where it starts to bend or
what?
Hoping you know what I mean and will punch my ticket,
Dan
-----------------------------------------------------------------
List archives located at: https://mail.dcsol.com/login
username "rebel" password "builder"
Unsubscribe: rebel-builders-unsubscribe@dcsol.com
List administrator: mike.davis@dcsol.com
-----------------------------------------------------------------