fiber vs. metal lock nuts
Posted: Sun Feb 19, 2012 4:11 pm
Assuming equal or better strength, is there any application where a metal
self-locking nut (ex. MS21042) should not be used instead of a fiber nut?
The MS21042's have a smaller wrench bearing area, but are lighter. It has
been suggested the metal grip may be harder on bolt threads, affecting bolt
re-use, but other than those that...what advantage does a fiber nut have
over a metal self-locking nut, if any?
Ron
-----------------------------------------------------------------
List archives located at: https://mail.dcsol.com/login
username "rebel" password "builder"
Unsubscribe: rebel-builders-unsubscribe@dcsol.com
List administrator: mike.davis@dcsol.com
-----------------------------------------------------------------
self-locking nut (ex. MS21042) should not be used instead of a fiber nut?
The MS21042's have a smaller wrench bearing area, but are lighter. It has
been suggested the metal grip may be harder on bolt threads, affecting bolt
re-use, but other than those that...what advantage does a fiber nut have
over a metal self-locking nut, if any?
Ron
-----------------------------------------------------------------
List archives located at: https://mail.dcsol.com/login
username "rebel" password "builder"
Unsubscribe: rebel-builders-unsubscribe@dcsol.com
List administrator: mike.davis@dcsol.com
-----------------------------------------------------------------